Hook up honeywell thermostat heat pump, where to locate & mount a room thermostat & what spots to avoid
Brumbaugh, ISBN v. Too many wires bunched up for me to see. Appreciated your quick response - thanks again1 Robert Reply: Do you follow which ones to do this to?
I'll hit you with my heat pump efficient, set back questions tomorrow. Do not put your chat websites for dating thermostat in the trash if it contains mercury in a sealed tube.
Pay particular attention to the following to help sort out what you've got or what type of thermostat you need:. Do not put your old thermostat in the trash if it contains mercury in a sealed tube.
My AC compressor was not turning on. Calling Honeywell with the right product number Tel: Or do I need to the run to the store behind the 8 inches of snow falls? Only way to turn off the blower is to disconnect the tstat or unplug the blower.
Even if i turn it off, it still runs. I had a simple Carrier thermostat before that, but it was pretty basic, no programming, so I upgraded and got the wrong one.
Wiring Set-Up Explained
Posted In Thermostatic Controls. Orange — This wire connects to your heat pump if you have one. Robert, I can't know what your system's yellow wire is doing, but by generic color code convention see tinder hookup lines. Thank you so much for your site!
I pulled the wires apart a bit. Follow the brown wire from "C" on the board into the box with all the low voltage wire meeting up.
If you have easy access to the existing thermostat wires, just remove and follow the same path with the new set of wires. Here are the pics.
And yeah, I wasn't sure about the wire nuts, but was screwing them on, half-heartedly, anyway. If your hook up honeywell thermostat heat pump is controlling only a heating system or only an air conditioning system, you will only have a red wire, and a white wire coming form the inside unit, to the outside unit.
My old thermostat had no wire lettering and that was making it frustrating trying to install my programmable thermostat.
After searching hi and low, your site was the only one that provided correct information on rewiring an old thermostat to a digital thermostat. I double checked, the correct number was selected. I want to make sure I'm right about this, but check out these pics, you can just see where the metal is showing even before I moved the wires around it's actually much farther out now, is just hanging free.
4 Wire Honeywell Thermostat Wiring
Any sense of how I can verify that the auxiliary heat is no longer always being used? Note that there are holes on both sides where the arrows point: What exactly does that do?
Then feed new wires with a fish tape Klein Tools.